Development of Maize Stalk Cellulose Fiber Reinforced Calcined Kaolinite Clay Geopolymer Composite

Authors

  • Addisu Workiye School of Mechanical and Industrial Engineering, Addis Ababa Institute of Technology, Addis Ababa, Ethiopia
  • Eyassu Woldsenbet Addis Ababa Institute of Technology, Addis Ababa University, Addis Ababa, Ethiopia

DOI:

https://doi.org/10.46604/peti.2020.4599

Keywords:

geopolymer, maize, fiber, kaolin, composite

Abstract

In recent years the popularity of ecological and renewable materials has grown. Aware of the availability of local resources and economic grounds, the attention is paid to the development geopolymer composite. Geopolymers are inorganic polymers that are formed by the polymerization reaction of silico-aluminate and silico-oxide. The aim of the research was to develop single maize stalk cellulose fiber reinforced calcined kaolinte caly based geopolymer composite. Kaolinite clay was characterized for its chemical composition from two different sites located in Ethiopia to use as precursor material. In addition to that, single maize stalk fiber was extracted from the maize stalk local variety by using a retting process, sodium hydroxide purity 98 % used for chemical treatment of the fiber for 30 minutes and its tensile strength 1184 Mpa and young modulus 16 Gpa were determined based on AST M D3822 to use as reinforcement. Sodium hydroxide and sodium silicate in appropriate ratio were used as an alkaline activator. Therefore,  the geopolymer composite developed from chemical treated short single maize stalk cellulose fiber and calcined kaolinite clay based geopolymer matrix activated by sodium water glass.  Geopolymer composites reinforced with 0 weight%, 0.1 weight%, 0.2 weight%, 0.6 weight%, and 1 weight% maize stalk single cellulose were prepared and tested for compression strength according to AST M C 1424. Measured compression strength ranged from 16 Mpa up to 27 Mpa. The result shows that the appropriate addition of single maize stalk cellulose  fibers can improve the Compression strength of a calcined kaolinite based geopolymer

Author Biography

Eyassu Woldsenbet, Addis Ababa Institute of Technology, Addis Ababa University, Addis Ababa, Ethiopia

Proffesor ,Addis Ababa institute of Technology School of mechanical and Industrial engineering

References

A. K. Mohanty, M. Misra, and L. T. Drzal, Natural fibers,biopolymers,and biocomposites, 1st ed. New York: CRC Press, 2005.

J. A. Youngquist, B. E. English, H. Spelter, and P. Chow, “Agricultural fibers in composition penels,” Proceedings of the 27th International Particleboard /Composite Materials Symposium, 1993, pp. 133-152.

D. O. Ekhuemelo, “Assessment of fiber characteristics and suitability of maize husk and stalk for pulp and paper production,” Journal of Research in Forestry, Wildlife and Environmental, vol. 5, no. 1, pp. 41-49, March 2013.

L. Zhang, Z. Yang, and H. Guo, “Tensile Properties of Maize stalk rind,” Bioresource, vol. 11, no. 3, pp. 6151-6161, May 2016.

P. Baranitharan and G. Mahesh, “Alkali treated maize fiber reinforced with epoxy polymer matrix composites,” International Journal of Innovative Science and Modern Engineering, vol. 2, no. 5, pp. 1-7, April 2014.

N. Reddy and Y. Yang, “Biofibers from agricultural byproducts for industrial applications,” Trends in Biotechnology, vol. 23, no. 1, pp. 22-27, January 2005.

G. Henrikson, D. E. Akin, R. T. Hanlin, C. Rodriguez, D. D. Archibald, L. L. Rigsby, and K. L. Eriksson, “Identification and retting efficiencies of fungi isolated from dew-retted flax in the United states and Europe,” Applied and Environmental Micropbiology, vol. 63, no. 10, pp. 3950-3956, October 1997.

I. Doraiswamy and P. Chellamani, Pineapple leaf fibers, 1st ed. North Carolina: North Carolina State University, 1993.

M. Dauda, M. Yoshiba, K. Miura, and S. Takahashi, “Processing and mechanical properties of long maize fibers reinforced polypropylene composites,” Transactions of the Materials Research Society of Japan, vol. 26, no. 4, pp. 1083-1090, January 2001.

S. Bavan and M. K. G. Channabasappa, “Examination of tensile strength and FTIR features of maize fibers reinforced polymer composite,” International Journal on Recent Trends in Engineering And Technology, vol. 5, no. 4, pp. 27-30, March 2011.

H. H. Murray, “Overview clay mineral application,” Applied Clay Science, vol. 5, no. 5-6, pp. 379-395, March 1991.

H. H. Murray, “Traditional and new applications for kaolin,smectite and palygorskite:a general over view,” Applied Clay Science, vol. 17, no. 5-6, pp. 207-221, March 2000.

G. Bedassa, “Characterization of the genesis of belessa kaolin occurrences, hosaina area.” Master thesis, Deptment Resource Geology, Addis Ababa University, Addis Ababa, June 2017.

B. B. Sabir, S. Wild, and J. Bai, “Metakaolin and calcined clays as pozzolans for concrete,” Cement and Concrete Composites, vol. 23, no. 6, pp. 441-454, December 2001.

A. Nmir, N. Hamdi, O. Yazoghli-Marzoul, M. Duc, and E. Srasra, “Synthesis and characterization of kaolinite based geopolymer: Alkaline activation effect on calcined kaolinitic clay at different temperature,” Journal of Materials and Environmental Science, vol. 8, no. 2, pp. 676-690, 2017.

J. Davidovits, “Properties of geopolymer cement,” Proceedings First International Conference on Alkaline Cements and Concretes, 1994, pp. 131-149.

S. N. Janne Paulin and B. P. Michael Angelo, “Development of abaca fiber reinforced foamed fly ash geopolymer,” MATEC Web of Conferences, vol. 156, pp. 1-8, 2018.

L. C. Silva, R. A. dos Reis Ferreira, et al., “Optimization of metakaolin based geopolymer composite using sisal fibers,response surface methodology and canonical analysis,” International Journal of Advanced Engineering Research Science(IJAERS), vol. 6, no. 4, pp. 32-44, April 2019.

M. Ravi, “Biocomposite panels from recycled wood chips for sustainable building applications,” Master thesis, Deptartment Civil Engineering, University Of British Columbia, Vancouver, August 2019.

D. Wattanasiriwech, T. Munmueangkham, and S. Wattanasiriwech, “Impact strength and physical properties of geopolymer composites reinforced with bagasse cellulose fibers,” 2018 World Congress on Advances in Civil, Environmental & Materials Research (ACEM18), August 2018, pp. 1-7.

A. S. Virk, “Numerical models for natural fiber composites with stochastic properties,” Ph.D. dessertation, School of Marine Science and Engineering, University of Plymouth, Plymouth, 2010.

N. Reddy and Y. Yang, Innovative biofibers from renewable resources, 1st ed. Verlag Berlin Heidelberg: Springer, 2015.

K. Korniejenko, E. Fraczek, E. Pytlak, and M. Adamski, “Mechanical properties of geopolymer composites reinforced with natural fibers,” International Conference on Ecology and New Building Material Products, 2016, pp. 388-393.

M. C. Symington, W. M. Banks, and O. D. West, “Tensile testing of cellulose based natural fibers for structural composite applications,” Journal of Composite Material, vol. 43, no. 9, pp. 1083-1108, 2009.

National ready mixed Concrete association(NRMCA) “Concrete in practice” http://welschreadymix.com/wp- content/uploads/2016/04/CIP35- Testing_Compresive_Strength_of_Concrete.pdf, June 2017.

Downloads

Published

2020-08-26

How to Cite

[1]
Addisu Workiye and Eyassu Woldsenbet, “Development of Maize Stalk Cellulose Fiber Reinforced Calcined Kaolinite Clay Geopolymer Composite”, Proc. eng. technol. innov., vol. 16, pp. 30–38, Aug. 2020.

Issue

Section

Articles