Online MEMS-Based Specific Gravity Measurement for Lead-Acid Batteries

Authors

  • Yashwant Gulab Adhav Department of Instrumentation and Control Engineering, Cummins College of Engineering for Women, Pune, India
  • Dayaram Nimba Sonawane Department of Instrumentation and Control Engineering, College of Engineering, Pune, India
  • Chetankumar Yashawant Patil Department of Instrumentation and Control Engineering, College of Engineering, Pune, India

DOI:

https://doi.org/10.46604/aiti.2023.8964

Keywords:

Kordash chart, lead-acid batteries, MEMS, specific gravity, temperature compensation

Abstract

Traditional methods for measuring the specific gravity (SG) of lead-acid batteries are offline, time-consuming, unsafe, and complicated. This study proposes an online method for the SG measurement to estimate the state-of-charge (SoC) of lead-acid batteries. This proposed method is based on an air purge system integrating with a micro electro mechanical system sensor. Through the proposed strategy, the SoC measurement achieves up to ±1% accuracy. The technique has an SG accuracy of ±0.002% which is better than the glass hydrometer accuracy of ±0.005% in the battery charge reading. The experimental results show that the high accuracy and precise measurements of SG and SoC can be conducted by using the proposed method.

References

S. Kim, M. Kwon, and S. Choi, “Operation and Control Strategy of a New Hybrid ESS-UPS System,” IEEE Transactions on Power Electronics, vol. 33, no. 6, pp. 4746-4755, June 2018.

M. Lei, Z. Yang, Y. Wang, H. Xu, L. Meng, J. C. Vasquez, et al., “An MPC-Based ESS Control Method for PV Power Smoothing Applications,” IEEE Transactions on Power Electronics, vol. 33, no. 3, pp. 2136-2144, March 2018.

A. Clerici, E. Tironi, and F. C. Dezza, “Multiport Converters and ESS on 3-kV DC Railway Lines: Case Study for Braking Energy Savings,” IEEE Transactions on Industry Applications, vol. 54, no. 3, pp. 2740-2750, May-June 2018.

B. Vulturescu, S. Butterbach, and C. Forgez, “Experimental Considerations on the Battery Lifetime of a Hybrid Power Source Made of Ultracapacitors and Lead-Acid Batteries,” IEEE Journal of Emerging and Selected Topics in Power Electronics, vol. 2, no. 3, pp. 701-709, September 2014.

M. Greenleaf, O. Dalchand, H. Li, and J. P. Zheng, “A Temperature-Dependent Study of Sealed Lead-Acid Batteries Using Physical Equivalent Circuit Modeling with Impedance Spectra Derived High Current/Power Correction,” IEEE Transactions on Sustainable Energy, vol. 6, no. 2, pp. 380-387, April 2015.

P. B. L. Neto, O. R. Saavedra, and L. A. de S. Ribeiro, “A Dual-Battery Storage Bank Configuration for Isolated Microgrids Based on Renewable Sources,” IEEE Transactions on Sustainable Energy, vol. 9, no. 4, pp. 1618-1626, October 2018.

J. M. Acevedo, A. M. C. Paz, S. Fernandez-Gomez, and M. L. Soria, “Life Testing of Plastic Optical Fibers for Lead-Acid Battery Fast Charge Equipment,” Annual Reliability and Maintainability Symposium, pp. 126-131, January 2008.

A. M. C. Y. Paz, J. M. Acevedo, J. D. Gandoy, and A. del R. Vazquez, “Multisensor Fibre Optic for Electrolyte Density Measurement in Lead-Acid Batteries,” IECON 2006 - 32nd Annual Conference on IEEE Industrial Electronics, pp. 3012-3017, November 2006.

C. Y. Patil and Y. G. Adhav, A Lead Acid Battery Charge Monitoring System, Indian Patent, 15/2020,16896, April 10, 2020.

J. Mucko, “A Possibility of the State of Charge Monitoring of the Lead-Acid Battery by Means of Current Pulses of a Given Value,” 14th Selected Issues of Electrical Engineering and Electronics (WZEE), article no. 8748988, November 2018.

S. Piller, M. Perrin, and A. Jossen, “Methods for State-of-Charge Determination and Their Applications,” Journal of Power Sources, vol. 96, no. 1, pp. 113-120, June 2001.

P. Křivk, “Methods of SoC Determination of Lead Acid Battery,” Journal of Energy Storage, vol. 15, pp. 191-195, February 2018.

G. P. Hancke, “A Fiber-Optic Density Sensor for Monitoring the State-of-Charge of a Lead Acid Battery,” IEEE Transactions on Instrumentation and Measurement, vol. 39, no. 1, pp. 247-250, February 1990.

M. Zhao, J. Long, Y. Chen, B. B. Luo, and J. Liu, “Surplus Electric Quantity Online Examination System of Lead-Acid Battery Based on ARM,” World Automation Congress, pp.1-4, September 2008.

S. S. Patil, V. P. Labade, N. M. Kulkarni, and A. D. Shaligram, “Analysis of Refractometric Fiber Optic State-of-Charge (SoC) Monitoring Sensor for Lead Acid Battery,” Optik, vol. 124, no. 22, pp. 5687-5691, November 2013.

A. Hossain and M. J. Dwyer, “A New Type of Liquid Density Transducer Based on the Principle of Linear Variable Differential Transformer,” SIcon/01. Proceedings of the First ISA/IEEE. Sensors for Industry Conference (Cat. No.01EX459), pp. 270-275, November 2001.

M. Morbel, H. J. Kohnke, and J. Helmke, “Monitoring of Lead Acid Batteries Continuous Measurement of the Acid Concentration,” INTELEC 05 - Twenty-Seventh International Telecommunications Conference, pp. 263-268, September 2005.

A. M. Cao-Paz, L. Rodríguez-Pardo, and J. Fariña, “Density and Viscosity Measurements in Lead Acid Batteries by QCM Sensor,” IEEE International Symposium on Industrial Electronics, pp.1290-1294, June 2011.

X. Lu, L. Hou, L. Zhang, Y. Tong, G. Zhao, and Z. Y. Cheng, “Piezoelectric-Excited Membrane for Liquids Viscosity and Mass Density Measurement,” Sensors and Actuators A: Physical, vol. 261, pp. 196-201, July 2017.

M. Heinisch, T. Voglhuber-Brunnmaier, E. K. Reichel, I. Dufour, and B. Jakoby, “Application of Resonant Steel Tuning Forks with Circular and Rectangular Cross Sections for Precise Mass Density and Viscosity Measurements,” Sensors and Actuators A: Physical, vol. 226, pp. 163-174, May 2015.

T. L. Wilson, G. A. Campbell, and R. Mutharasan, “Viscosity and Density Values from Excitation Level Response of Piezoelectric-Excited Cantilever Sensors,” Sensors and Actuators A: Physical, vol. 138, no. 1, pp. 44-51, July 2007.

C. Tang and J. T. Lin, “Online Autonomous Specific Gravity Measurement Strategy for Lead-Acid Batteries,” IEEE Sensors Journal, vol. 20, no. 4, pp. 1980-1987, February 2020.

K. W. Park and H. C. Kim, “High Accuracy Pressure Type Liquid Level Measurement System Capable of Measuring Density,” TENCON 2015 - 2015 IEEE Region 10 Conference, article no. 7372925, November 2015.

J. Y. Kim, S. E. Bae, T. H. Park, S. W. Paek, T. J. Kim, and S. J. Lee, “Wireless Simultaneous Measurement System for Liquid Level and Density Using Dynamic Bubbler Technique: Application to KNO3 Molten Salts,” Journal of Industrial and Engineering Chemistry, vol. 82, pp. 57-62, February 2020.

C. Zhang, Y. Huang, Y. Fang, P. Liao, Y. Wu, H. Chen, et al., “The Liquid Level Detection System Based on Pressure Sensor,” Journal of Nanoscience and Nanotechnology, vol. 19, no. 4, pp. 2049-2053, April 2019.

Y. Guo, “A Sensor of Sulfuric Acid Specific Gravity for Lead-Acid Batteries,” Sensors and Actuators B: Chemical, vol. 105, no. 2, pp. 194-198, March 2005.

C. Liu, W. Ren, B. Zhang, and C. Lv, “The Application of Soil Temperature Measurement by LM35 Temperature Sensors,” Proceedings of 2011 International Conference on Electronic & Mechanical Engineering and Information Technology, vol. 4, pp. 1825-1828, August 2011.

Downloads

Published

2023-04-01

How to Cite

[1]
Yashwant Gulab Adhav, Dayaram Nimba Sonawane, and Chetankumar Yashawant Patil, “Online MEMS-Based Specific Gravity Measurement for Lead-Acid Batteries”, Adv. technol. innov., vol. 8, no. 2, pp. 136–149, Apr. 2023.

Issue

Section

Articles