Optical Design of Full View Lens based on Energy Luminance Analysis Chart of Stray Light

Authors

  • Jen-Yu Shieh
  • Min-Nen Lee

Abstract

This paper presented optical design software (CODE V) in combination with stray light simulation software (Light Tools) to develop and analyze the influence of 360 degree lens stray light on MTF. We study the pupil entrance position of 2P3G lens group, set the pupil entrance position of the same inside-aperture lens which locates in the Lens 2(S2) or Lens 3(S1) surface. After simulation and analysis of ray tracing software, we get the best pupil entrance position of the lens to achieve the best efficiency and resolution. In addition, through the energy luminance analysis chart of stray light, comparison between this simulation and the actual test verifies that this design is consistent with the fact, so this method provides a reference for the future optical design and manufacture.

References

Y. J. Lin, “Study on stray light suppressing in cell phone lens,“ Graduate Institute of Electro-Optics and Material Engineering, National Formosa University, Master Thesis, 2007.

Y. F. Liang, “Application of the single wavelength collimated laser on the analysis and improvement of the stray light of lens unit＂ Graduate Institute of Electro-Optics and Material Engineering, National Formosa University, Master Thesis, 2008.

Code V : Website http://www.opticalres.com/

C. F. Ho, T. M. Huang, S. T. Chang, “Stray light analysis and suppression in optical system,“ Instruments Today, vol.27, no.4, 2004, pp. 81-87.

X. T. Li, Z. F. Cen, “Geometrical optics, aberrations, optical design,” Zhejiang University Press, pp. 48-252, 2004.

Y. X. Chang, “Optical design”, Beijing: Science Publishing Company (in Chinese), 1983.

W. X. Sun, “optical design technology paraxial ray tracing,” National Formosa University, 2004.

Downloads

Published

2011-10-01

How to Cite

[1]
J.-Y. Shieh and M.-N. Lee, “Optical Design of Full View Lens based on Energy Luminance Analysis Chart of Stray Light”, Int. j. eng. technol. innov., vol. 1, no. 1, pp. 27–34, Oct. 2011.

Issue

Vol. 1 No. 1 (2011)

Section

Articles

License

Copyright Notice

 

Submission of a manuscript implies: that the work described has not been published before that it is not under consideration for publication elsewhere; that if and when the manuscript is accepted for publication. Authors can retain copyright in their articles with no restrictions. Also, author can post the final, peer-reviewed manuscript version (postprint) to any repository or website.

 

 

Since Jan. 01, 2019, IJETI will publish new articles with Creative Commons Attribution Non-Commercial License, under Creative Commons Attribution Non-Commercial 4.0 International (CC BY-NC 4.0) License.

The Creative Commons Attribution Non-Commercial (CC-BY-NC) License permits use, distribution and reproduction in any medium, provided the original work is properly cited and is not used for commercial purposes.